Hama 00124584 Bedienungsanleitung Seite 2

2
G Operating instruction G Operating instruction
Controls and Displays
1. LED function display
2. Micro USB connector
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep these
instructions in a safe place for future reference. If you sell the device, please pass these operating
instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your attention to specific
hazards and risks.
1
Note
This symbol is used to indicate additional information or important notes.
2. Package Contents
• Car charger with permanently attached Micro USB cable
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial use only.
• Use the product for its intended purpose only.
• Do not operate the product outside the power limits given in the specifications.
• Protect the product from dirt, moisture and overheating, and only use it in a dry environment.
• Do not use the product in moist environments and avoid splashes.
• Do not bend or crush the cable.
• Always pull directly on the plug when disconnecting the cable, never on the cable itself.
• Do not drop the product and do not expose it to any major shocks.
• Keep this product, as all electrical products, out of the reach of children!
• Dispose of packaging material immediately according to locally applicable regulations.
• Do not modify the product in any way. Doing so voids the warranty.
2
Note
• When using this product, observe the applicable local traffic laws and regulations.
• Take care that components such as airbags, safety areas, controls, instruments, etc.
and visibility are not blocked or restricted.
4. Startup and Operation
Note – Connecting terminal devices
• Before connecting a terminal device, check whether the power output of the charger can
supply sufficient power for the device.
• Please refer to the instructions in the operating manual of your terminal device.
• Plug the charger into a car socket in the vehicle electrical system.
• When the power supply is active, the status LED (1) lights up in orange. The charger is now ready
for use.
• Connect the Micro USB connector (2) to the terminal device to be charged.
• Disconnect all cable and mains connections after use.
Note
For some vehicle types, the ignition has to be switched on to supply power to the 12 V car socket.
For more information, please refer to your vehicle's manual.
5. Care and Maintenance
• Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning
agents.
6. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failure to observe the operating
instructions and/or safety notes.
3