Bauknecht WATK Prime 8612 Kurzanleitung Seite 12

- Timer drying mode:
To set a specific drying time, press the "Trockenzeit" button
until the led for the desired time is illuminated. Values from
180 to 40 minutes are settable.
N.B.: always allow a cooling down period after drying before
opening the door.
5.
USING THE CORRECT AMOUNT OF DETERGENT. Pull out
the tray and pour detergent into the relative compartments
as described in "Detergent dispenser". This is only necessary
when using a wash only or a wash + dry programme.
6.
DELAYING THE START OF A PROGRAMME. To set a
programme to start at a later time, see the section "Options
and Functions".
7.
STARTING A PROGRAMME.
Press the START/PAUSE button. The corresponding indicator
light is illuminated, the door locks and the door open
symbol extinguishes. To change a programme while a cycle is
in progress, press START/PAUSE to pause the washer dryer
(the START/ PAUSE lamp flashes amber slowly); then select
the required cycle and press START/PAUSE again. To open the
door while a cycle is in progress, press START/PAUSE; the door
may be opened if the
PAUSE button again to resume the programme from where it
was paused.
8.
CANCELLING A RUNNING PROGRAMME (IF NECESSARY)
Press and hold the button
If the water level and temperature are low enough, the door
unlocks and may be opened.
The door remains locked if there is water in the drum. To
unlock the door, switch the washer dryer on and select the
SCHLEUDERN & ABPUMPEN
and the door unlocks at the end of the programme.
9.
SWITCHING THE WASHER DRYER OFF AT THE END OF A
PROGRAMME.
At the end of the programme, the door open
switch on. The door can only be opened when the
symbol lights. Check that the door open light is on, then
open the door and remove the laundry.
Press to switch the washer dryer off. To save energy, if the
washer dryer is not switched off manually with the
button, it turns off automatically approximately 30 minutes
after the end of the programme.
Leave the door ajar to let the interior of the washer dryer dry.
12
symbol lights. Press the START/
until the washer dryer stops.
programme. The water is emptied
light will