AEG FR 5554 Bedienungsanleitung, Garantie Seite 31

CAUTION:
In the case of foodstuffs which are too moist (e.g.
frozen chips etc.) large amounts of foam may form,
which under certain circumstances may cause the
oil to overflow.
Use
1. Make sure that the appliance is unplugged and
switched off (The control lamps are off.).
2. Take the lid off the deep fryer.
3. Remove the frying basket and fill the container with
oil or grease (maximum 3 l). The filling level must be
located between the minimum and the maximum
level.
4. Insert the plug into a 230 V, 50 Hz power socket. The
red control lamp lights up. Set the desired tempera-
ture by turning the temperature control (2).
5. The green control lamp lights up. Once the set tem-
perature has been reached the green control lamp
goes off. Place the frying basket containing the items
to be fried carefully into the hot fat.
6. The green control lamp switches on and off several
times during frying. This is normal and it indicates
that the temperature is controlled by the thermostat
and is being maintained. Once the frying time is over
(the frying times are to be found on the packaging of
the food or in the recipe), please take out the frying
basket.
7. Let the oil drip from the food being fried.
8. In order to switch off the machine, please turn the
temperature regulator to OFF and remove the plug
from the socket.Wind the mains lead up in the form
of a spiral in the cable compartment.
Cleaning
WARNING:
Always pull out the plug from the mains socket before
cleaning and wait until the unit has cooled down.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Under no circumstances should the device be
immersed in water for cleaning.
Deep frying fat container
• In order to change the oil, pull out the deep frying
fat container and pour the oil out at the side.
• Clean the deep frying fat container, the lid and the
housing with a damp clothand household detergent
if necessary. Please do not immerse in water.
• The deep frying basket can be cleaned in the usual
way in soapy water.
05-FR 5554 AEG.indd 31
Housing
Clean the housing after use with a slightly damp cloth.
Changing the Odour and Fat Vapour Filter
The filter in the lid can be replaced.
• Then reassemble the cover. Please note the position
of the holes. The holes of the inner cover must be
positioned accurately over those of the filter cover.

NOTE:
When these filters have been used up it is possible to
cut universal filters to size, e.g. from cooker hoods.
Troubleshooting
Device is not working
Troubleshooting:
• Check the mains connection.
• Check the position of the thermostat.
Other possible causes:
The device is fitted with a safety switch (7).
This prevents the heater being switched on accidentally.
Troubleshooting:
Check that the control element is correctly in place.
Overheating Protection
• If you should accidentally switch on your deep fat
fryer when there is no oil or fat in it the overheating
protection is automatically turned on. The appliance
is no longer ready to be used. Unplug the deep fryer.
• Only after the device has been left to cool down
completely should the „RESTART" button (8) on the
rear of the control element be operated in order to
use the deep fat fryer again. For this you should use a
plastic or wooden object that is the least 4 cm long.
English
31
• Unlatch the filter from
the inside of the lid by
pressing in the catches.
You can use tongs if
necessary.
• Remove the inner
cover.
• Replace the filter.
31.08.11 09:55