Operation; Intensive Setting - Siemens LC 259BA60 Gebrauchsanleitung Und Montagealeitung

Operation

Light
NOTE: It is recommended to switch on the
blower when you start cooking and not to
switch it off again until several minutes after you
have finished cooking. In this way the kitchen
fumes are removed most effectively.
Switching on the fan and selecting the
fan settings
Press button +. If kitchen fumes are thicker,
press button + again. The fan setting is
increased by one.
To switch back by one setting, press
button –.
Switching off the fan
Press button 0.
The displayed 0 goes out shortly
afterwards.

Intensive setting

The Intensive setting ç generates maximum
performance. It can be used if thick fumes or
strong odours occur temporarily.
Keep pressing button + until
If the Intensive setting is not switched off
by hand, the fan automatically switches back
to setting 2 after 10 minutes.
Fan follow-on
Press the button.
The fan continues to run at step 1 for 10
minutes, and at the same time a dot flashes in
the display. After this period the fan switches
off automatically.
24
Fan OFF
Reduce fan speed
ç is displayed.
Display for fan setting
Fan ON and increase speed
Intensive setting
Light
The light can be switched on and off
independently of the fan.
To adjust the luminosity, hold down the
button until the required luminosity is obtained.
Saturation displays
When the grease filters or the activated
carbon filter are saturated, a signal sounds for
6 seconds after the fan is switched off.
Display # or C is lit.
Exhaust-air mode: #
Circulating-air mode: C
The grease filters should now be cleaned or
the activated carbon filter changed.
To cancel the display, press the
Switching the acoustic signal off and on
When a button is pressed, an
acknowledgement signal sounds.
To switch off the acoustic signal,
simultaneously press the
approx. 3 seconds. An acknowledgement signal
sounds.
To switch on the acoustic signal, repeat the
process.
Fan follow-on
0
0 button.
0 and + buttons for