Cleaning And Maintenance; Cleaning The Filter; Technical Data - Superior XJ-6K111 Bedienungsanleitung

ensure the oil/fat is covered, please always shut the device lid.
• The oil/fat should be regularly replaced, after approx. 20 frying cycles or when it turns brown in
colour.
• Always remove residues of the fried food from the oil/fat.

CLEANING AND MAINTENANCE

Caution!
Always first switch off and unplug the device from the mains when cleaning, and ensure it is allowed
to thoroughly cool down.
• Do not allow any dirt or stains to become dried in. Always clean the device and accessories as
soon as possible after use.
• The accessories can be washed up as normal. When doing so, ensure they are thoroughly dried
before being replaced back in the device. Take off the fry basket handle when cleaning.
• The external surfaces of the device can be cleaned using a damp cloth and a mild detergent.
When doing so, be careful to ensure that no moisture is allowed to infiltrate inside the device
during this process (e.g. at the temperature adjuster). Subsequently, use a soft cloth to wipe the
surfaces dry.
• When cleaning the device, do not use any harsh cleaning materials, alcohol, sandpaper, scouring
pad, wire brush or similar hard objects, which could damage the outer surfaces.
• When emptying the fry container, remove the lid from the device by simply pulling it upwards. If
the fat has hardened, remove it from the fry container using a plastic spoon. If the fat is viscous
or you have used oil to fry, the fat / oil contained in the fry container can be emptied out via the
left rear corner of the device. For this purpose, a drain channel is included in the plastic. Carefully
tilt the whole device in the direction of the left rear corner to direct the contents into a suitable
container or a plastic bag. The viscous fat / oil will now run out of the fry container and can thus
be removed.
• Do not use any pointed or sharp-edged objects in the fry container, since these may damage the
outer surfaces.
• Subsequently, wipe out the fry container to ensure that the last remaining traces of fat / oil have
been removed from the device.
• Never immerse the device in water or wash directly with water.
• The power cord and plug should always only be dusted off with a dry cloth.

Cleaning the filter:

• Open the filter cover on the inner side of the lid using a suitable recessed head screwdriver and
remove the used filter attachment.
• Wipe the lid and the interior area using a damp cloth and a mild detergent. Subsequently, wipe
the surfaces dry using a soft cloth.
• Rinse out the filter, using both water and a cleaning agent. Subsequently, ensure the filter is
thoroughly dried.
• Replace the filter attachment and ensure the filter lid is shut correctly once again.

TECHNICAL DATA

Model
Voltage
Output
Protective classification
XJ-6K111
220 - 240 V ~ 50 Hz
2000 Watt
I
14 14