Endress+Hauser PMD75 Installationsanleitung Seite 6

Sensor for PMD75
Mounting of sensor assembly
1. Aluminum housing T14/T15
1
2. Stainless steel housing T17
1
Mounting of electronics
Re-assembly of the complete instrument has to be done in the reverse order to dismounting of sensor assembly (step 6 ... 1 ).
After appropriate assembly the housing can be turned for more than a complete turn (380°) until the locking ring stops the rotation.
Commissioning
Re-install instrument.
Connect cables at terminal.
Adjust housing to desired position
After the alignment of the housing tighten the set
and ground of the housing. Especially the electromagnetic
Adjustment / Calibration
After the assembly has been completed the instrument is operable again.
The following settings have to be done according to the operating manual.
Perform a general reset to factory settings, the customer calibration data are deleted.
Adjust the measuring range.
Perform a position adjustment.
6
2
Sensor19
2
Sensor23
and fasten the set screw.
3
5 x
Sensor20
3
Sensor24
screw firmly to achieve an optimal potential equalization between process vessel
compatibility of the electronics will be improved.
4
1.
4 x
2.
2 mm
Sensor21
4
3 mm
9 x
Sensor25
Sensor22
Sensor26
Endress + Hauser