Status Led - Phottix Ares Flash Trigger Benutzerhandbuch

Status LED

1. The Status LED on the front of the Phottix
Ares transmitter will ash green approximately
every one second when in standby mode. It will
turn red when a signal is being transmitted.
2. The Status LED on the Phottix Ares receiver
will ash green approximately every one
second while in standby mode. The LED will
turn red when a signal is received from the
transmitter.
3. When battery power is low the Status LED on
the transmitter or receiver will quickly ash red
indicating low power and the need to change
batteries.
Turning Transmitter and Receiver
On/O
1. To turn on the Phottix Ares transmitter or
En
receiver - move the power switch to the "ON"
position.
2. To turn o the Phottix Ares transmitter or
receiver - move the power switch to the "OFF"
position.
Setting Channels
1. The Phottix Ares has eight channel settings.
2. Press the Channel Adjustment Buttons (left
or right) on the transmitter or receiver to set
the channel.
3. Channel Numbers 1 to 8 will illuminate on
the transmitter or receiver to indicate which
channel the device is set to.
4. Phottix Ares transmitters will only trigger
receivers set to the same channel.
INSTRUCTION MANUAL
5