Bowers & Wilkins P3 Serie 2 Handbuch Seite 4

3. Connecting your headphones
Your P3 Series 2 Headphones can be connected
to any audio device with a 3.5mm jack headphone
output. The remote and mic cable fitted to P3
Series 2 Headphones incorporates an iPhone, iPod
and iPad compatible microphone and audio control.
Its use is described in the following section of this
manual.
If using your P3 Series 2 Headphones with anything
other than an Apple device the remote and mic cable
may occasionally result in unreliable connection.
For such a case the supplied universal cable can be
substituted. Detaching the remote and mic cable
and fitting the universal cable is described below and
illustrated in Diagram 4.
• Unfold the headphones and remove each earpad
by gently pulling it away from the body of the
earpiece. Removing the earpads reveals the cable
connection plugs and sockets.
• Working on one earpiece at a time, gently
grasp the connection plug and pull it from the
connection socket. Pull on the plug rather than
the cable itself. Lift the cable out of its routing
channel.
• With the remote and mic cable now disconnected,
take the universal cable and identify the left and
right connection plugs. L or R identification is
moulded into each plug.
• Insert the left connection plug into the left
earpiece socket and press the cable into its
routing channel. Repeat for the right earpiece.
• Replace the earpads. Make sure that the earpad
location pins and sockets engage accurately.
4. Using your P3 Series 2 Headphones
with iPhone, iPad or iPod
Your P3 Series 2 Headphones incorporate a
combined microphone and audio control, integrated
within the remote and mic cable, that enables you to
make or answer calls while wearing the headphones.
The control also enables you to play, pause and skip
songs. The microphone and control is illustrated in
Diagram 5.
The control incorporates three click switches, one in
the middle and one at either end, and operates as
follows:
• Click the end switch engraved "+" to increase
phone or song volume.
• Click the end switch engraved "–" to decrease
phone or song volume.
• Click the middle switch once to answer a call.
• Click the middle switch once to end a call.
• Click the middle switch once to play or pause
a song.
• Click the middle switch twice to skip to the
next song.
• Click the middle switch three times to skip to the
previous song.
Diagram 4
Changing the cable
1x
1x
2x
3x
Diagram 5
The microphone and audio controls
L
4