Safety Instructions - i-tec USB-C Dual Display MST Gebrauchsanweisung

Note:
Windows OS: Setting of the MST mode with two connected monitors (HDMI and
Display port) is always dependent on the internal graphics card and hardware
specifications of the notebook / tablet (must support dual monitor set-up). To set
up two monitors, using of both the Windows control utility and the "Control panel
for the Intel HD Graphics" is required in some hardware combinations (item Display-
Multiple monitors). For the corresponding resolution, we also recommend setting
of the same refresh rate on both connected monitors. The third external 4K monitor
can be connected using i-tec USB 3.0 adapter (e.g. U3DP4K or U3HDMI4K) or the
FullHD+ monitor with other video adapters.
macOS: macOS does not support MST (2 monitors in the extended mode). The
second external 4K monitor can be connected using i-tec USB 3.0 adapter (e.g.
U3DP4K or U3HDMI4K) or the FullHD+ monitor with other video adapters.
For the corresponding resolution for internal graphics card, we recommend to
select "Default for Monitor", set resolution on the second external monitor and
restart your Mac device.
Most problems with the docking station and the connected peripherals can be
solved by using the ON/OFF switch or disconnecting the USB-C cable of the
docking station from the USB-C port on the PC / Mac / smartphone / tablet and its
reconnecting after about 10 seconds.
In case of problems with the USB-C docking station, contact our technical support:
support@itecproduct.com.

SAFETY INSTRUCTIONS

Do not expose to extreme temperatures and air humidity.
Ÿ
Use the equipment on flat surfaces – it will help avoid slipping and falling
Ÿ
on the ground.
Keep this manual for future reference.
Ÿ
In cooperation with the service department:
Verify functionality after falling into water or on the ground.
Ÿ
Verify functionality after the cover cracking.
Ÿ
Claim malfunctioning equipment according to the manual.
Ÿ
Quick Start
EN EN
06 08