Declaration Of Conformity - Klarstein 10026901 Handbuch

If really want to stop using it for a long time, please power off , and follow the above information to
clean it and dry it naturally, later keep it in the dry and clean place. Remember to keep the door a
little gap in order not to make the door seal stick with the cabinet.
5. Replacing The Lamp
1. Turn the thermostat to the off positin „0" and disconnect from the mains.
2. Remove all the food from the top shelf of the fridge and pull it forwards slightly.
3. The lamp is located in the back of the thermosat housing, remove the plastic lens by pressing the
front centre of the lens whilst pulling upwards on the small lip on the bottom of the lens at the
front.
4. Unscrew the lamp in a clockwise direction and screw a new lamp into the lamp holder in an
anti-clockwise direction until fi nger tight.
5. Replace the lens by locating the rear lug and pressing home fi rmly.
6. Set the thermostat to your preferred setting and close the door.
According to the European waste regulation 2012/19/EU this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this product is disposed of correct-
ly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailled information about recycling of this product, please
contact your local council or your household waste disposial service.

Declaration of Conformity

Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)
2014/53/EU (RED)
643/2009/EG (ErP)
Hints on Disposal
10