HomeMatic HM-LC-Bl1-FM Bedienungsanleitung Seite 16

Operating the device is only permitted with a
230 V/50 Hz alternating current network.
Work on the 230 V network is only permitted
by qualified electricians (in accordance with
VDE 0100).
Always observe the applicable accident pre-
vention regulations.
Disconnect the power to devices before wor-
king on them to prevent electrocution (switch
circuit breaker).
Ignoring installation instructions can cause
fires or other hazards (see sec. 6).
Do not open the device. It does not contain
any parts to be maintained by the user. In
case of a fault, please send the device to our
service department. This device is to be ope-
rated indoors only and keep away from the in-
fluences of humidity, dust and sunshine or
other radiating heat sources. Do not exceed
the capacity specified for the device. Make
sure that the specified wiring and wire cross-
sections are used when connecting to device
terminals.
30
Use only mains power capable buttons and
wires for connecting to button inputs!
Switch actuator:
Follow all technical specifications, especially
the maximum permitted switching capacity of
the relay and type of consumer to be con-
nected, before connecting the consumer! All
load specifications refer to resistive loads!
Blind actuator:
The actuator is only suitable for 230V a.c. mo-
tors!
Never connect three-phase a.c. motors or d.c.
motors!
If motors are connected to the output in paral-
lel with the actuator, make sure to observe the
motor manufacturer's specifications.
The motors can be damaged otherwise. Use
only blinds or shutters with limit switch (me-
chanical or electronic)!
Check the limit switch for the connected mo-
tors for proper adjustment before starting the
blind actuator!
31