Tacx i-Vortex Bedienungsanleitung Seite 6

training with the i-Vortex
tRaiNiNG With thE i-VORtEx
training data
Both during and after a training session you have the possibility to browse the training data using
arrow left and arrow
1. Stopwatch, time cycled
2. Distance covered in Km or Mi
3. Consumption in Kjoule or Kcal
4. Maximum and average speed
5. Maximum and average power
6. Maximum and average pedalling frequency
7. Maximum and average heart rate
average indicator
This function indicates if the training data in the yellow menu bar is right on, below or over average.
Setting training value
Using arrow up or arrow down
Setting training type
By pressing OK once the training type will start blinking. Using
switch between training types: Slope (incline in %), Power (watt) and Heart rate (in bpm). Pressing
OK saves the choice.
right. You can browse through the 7 following display functions:
you can adjust the setting's value while training.
arrow up or arrow down
Scope & error codes
you can
SCOPE
Scope speed
If the brake is incapable of attaining the power demanded at a given incline up- or down hill, virtual
speed is used. The speed indicated is the speed that corresponds to the set incline and current power
out put. Because it is not possible to set an even lower power for the brake, the indicated speed will
be higher. If uphill it is not possible to set an even higher power for the brake the indicated speed will
be lower. A horizontal bar will appear underneath the value in case of virtual speed.
Scope power
When the set power cannot be attained at the speed you are riding at a horizontal bar will appear
underneath the value for your information.
ERROR CODES
Error codes while riding
At www.tacx.com › SERVICE, you will find the FAQ pertaining to the i-Vortex. This is where you can find
updated information about what to do if an error code appears on your screen.
10 11
EN
NL
DE
FR