Tacx i-Vortex Bedienungsanleitung Seite 4

Starting up the first time & SEt uP
StaRtiNG uP thE FiRSt timE & SEt uP
When you start up the i-Vortex for the first time, there are a number of basic settings you will need to
input once.
Linking the brake
The i-Vortex computer executes an automatic search - magnifying glass is blinking – for a brake
when hooked up to the mains. When a brake has been found the serial number, the firmware version
number and voltage will appear on screen. After 3 seconds you will continue to SET UP.
Weight
Kg is blinking. Change from Kg to Lbs using
Use arrow right to go to the next step.
Speed
Km is blinking. Change from Km to Mi using
Use arrow right to go to the next step
Energy
Kcal is blinking. Change from Kcal to Kjoule using
Use arrow right to go to the next step
If you want to change the settings, press the
entire display will light up, after pressing
arrow up or arrow down.
arrow up or arrow down.
arrow up or arrow down.
arrow up and arrow down keys simultaneously for 3 seconds. The
OK you will enter the SET UP mode.
Settings before the start
SEttiNGS BEFORE thE StaRt
information screen
By pressing the arrow left
about the handle bar computer and brake will appear on the display.
Top right
Centre left
Centre right
Yellow bar
Bottom left
Bottom bar
You can leave the information screen by pressing
heart symbol with text HF OFF appears. Using
arrow right to leave the heart rate belt choice setting.
heart rate belt analogue
The heart symbol with text HF ON appears. When the heart rate signal is received the actual value
will appear where the three bars next to the heart symbol are.
6
and arrow right keys simultaneously for 3 seconds, general information
scale factor
firmware version brake
firmware version handle bar computer
ODO reading
body weight (kg/lbs)
speed (km/mi) & symbols for sound and battery
OK which will get you to heart rate settings. The
arrow down you can switch to other possibilities. Use
7
EN
NL
DE
FR