Faytech 1040 SI Bedienungsanleitung Seite 25

Setting up the faytech Touch software
To the right of the mouse icon are options to set different mouse-like modes.
Normal mode offers the most intuitive touch-operation.
: Allows the user to select an object or drag an object with the
Normal-Mode
touch pen or a finger. This is the best mode to use for most applications.
: The "click" is recognized when the screen is touched. To
Click on touch
initiate a new mouse-click, the display must be released and re-pressed.
: Contrary to the click
Click on release
click when the display is released.
Click on touch without moving cursor
click. The cursor follows the finger / pen movement.
understanding of this setting, try it with the
tab.
Tools
Click on release without moving cursor
the touch position except at the lift-off point. For a better understanding of
, it is generated
function in touch
: The first touch point generates a
For a better
application under the
Draw Test
: The cursor does not move to
44 faytech Ltd. 2009
C
Setting up the faytech Touch software
setting, try it with the Draw Test application under the Tools tab.
On the far right of the mouse icon, there is an
options are available for the faytech display in this submenu:
Enable Constant Touch:
l
determine if the most recent touched position is the same as the previously
touched point. If the difference is smaller than the defined area, the driver
does not generate any mouse movement which helps reduce system load.
Enable Auto Right Click:
l
the driver will generate a mouse right button click if this function is enabled.
Enable Touch:
l
not work!
a
Enable Cursor Stablization:
l
some noise to stabilize and smooth the touch points. When activated, the
user will experience a more stable cur
Option
is the function to check to enable the driver to
If the touch screen is touched for a specified time,
Be careful! If you don't check this box, the touch function will
A software filter exists inside the driver to filter
sor.
45
button. The following