Inserting The Batteries; Wall Installation; Private Branch Exchanges - AUDIOLINE BIGTEL 49 PLUS Bedienungsanleitung

Putting the Telephone into Operation

Inserting the batteries

Insert the batteries in the open
battery compartment.
Only use batteries of the type
AA 1.5 V. Pay attention to the
correct polarity. Close the
battery compartment cover.
The full range of telephone functions can only be used when the
batteries are correctly inserted and are not empty.
Caution: Always ensure that the telephone is not connected to
the telephone socket and/or power socket (option) when inser-
ting or replacing batteries.
When the batteries are empty, the
Replace the batteries.
Setting the time and date
The time and date are set via the menu. Refer to Page 28 for the se-
quence of menu option selections necessary.

Private branch exchanges

The information on Page 27 explains how to install your telephone in a pri-
vate branch exchange.
22
Service−Hotline Germany: Tel. 0180 5 001388, cost via German landline at time of going to print: 14 ct/min., different costs possible via mobile telephone systems
icon appears in the display.

Wall installation

The telephone can also be installed on a wall. You require two screws in
order to fix the telephone on a wall.
Feed the guide tabs (1) on the wall−mounting bracket (2) in the slots (3) on
the rear side of the telephone. Slide the wall bracket (2) 10 mm upwards
until it audibly snaps into place.
Warning: Ensure that there are no cables or pipes etc. under
the surface of the wall where you want to drill the holes.
Drill two holes whose distance apart corresponds to the bracket to be
used, insert the screws and allow them to project 5 mm from the wall.
Position the telephone on the bracket, fit the screws in the slots and slide
the telephone downwards a little.
Turn the receiver hook (4) in the receiver cradle 180° so that the receiver
can be hooked in.
3
3
1
4
4
2
4
4
4