Installation; Technical Data - Zanussi ZFC38402WA Benutzerhandbuch

Installation

Positioning
Warning! If you are discarding an old
appliance that has a lock or catch on the
lid, you must ensure that it is made unusable
to prevent young children being trapped
inside.
Important! The appliance shall have the plug
accessible after installation.
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar), but for op-
timum performance install this appliance at a
location where the ambient temperature corre-
sponds to the climate class indicated on the
rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.

Technical data

Dimension
Rising Time
The technical information are situated in the
rating plate on the external right side of the ap-
pliance and in the energy label.
www.zanussi.com
Height
Width
Depth
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power supply
socket is not earthed, connect the appliance
to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Ventilation requirements
1. Put the freezer in horizontal position on a
firm surface. The cabinet must be on all
four feet.
2. Make sure that the clearance between the
appliance and rear wall is 5 cm.
3. Make sure that the clearance between the
appliance and the sides is 5 cm.
The airflow behind the appliance must be suffi-
cient.
ZFC38402WA
876 mm
1600 mm
665 mm
55 h
ZFC31401WA
876 mm
1325 mm
665 mm
52 h
41