Operation - Zanussi ZFC38402WA Benutzerhandbuch

• It is advisable to wait at least four hours be-
fore connecting the appliance to allow the
oil to flow back in the compressor.
• Adequate air circulation should be around
the appliance, lacking this leads to over-
heating. To achieve sufficient ventilation fol-
low the instructions relevant to installation.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
Service
• Any electrical work required to do the serv-
icing of the appliance should be carried out
by a qualified electrician or competent per-
son.

Operation

Switching on
Insert the plug into the wall socket.
Turn the Temperature Regulator to the Full
Loaded position and let the appliance run for
24 hours to allow the correct temperature to
be reached before placing food inside.
Adjust the Temperature Regulator according
to the quantity of the stored foods.
A Temperature Regulator
B Half Loaded position
C Full Loaded position
www.zanussi.com
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in
either its refrigerant circuit or insulation materi-
als. The appliance shall not be discarded to-
gether with the urban refuse and rubbish. The
insulation foam contains flammable gases: the
appliance shall be disposed according to the
applicable regulations to obtain from your local
authorities. Avoid damaging the cooling unit,
especially at the rear near the heat exchanger.
The materials used on this appliance marked
by the symbol
Switching off
To turn off the appliance, turn the Temperature
Regulator to the "OFF" position.
Temperature regulation
The temperature within the appliance is con-
trolled by the Temperature Regulator situated
on the control panel.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward low-
er settings to obtain the minimum coldness.
A
• turn the Temperature Regulator toward
B
higher settings to obtain the maximum cold-
ness.
C
In case of freezing less food volumes, the
Half Loaded setting is the most suitable.
In case of freezing much food volumes, the Full
Loaded setting is the most suitable.
are recyclable.
35