Canvys PD-CP52SS Bedienungsanleitung Seite 45

Problem Check
(contd.)
4. Image is the signal cable: are both ends correctly con-
-
blurred or insta- nected
ble
the selected graphics mode: does the display
-
support the graphics mode of the graphics
board-/+
the selected resolution: is the device set to a
-
resolution of 1920 x 1080 at a refresh rate of
60 Hz (at resolutions below 1920 x 1080 , the
image is expanded (=> interpolated) which may
cause interpolation errors. As a result the im-
age may look blurred. However, this does not
indicate a device defect!)
Other remedies:
Select "Auto adjust" from the Position menu.
-
Select the H-Total and Phase functions from
-
the Position menu and change the settings to
achieve a sharp and stable image (these set-
tings may have to be repeated when you have
selected another graphics mode).
5. The image is the horizontal and vertical image position in the
-
not sized prop- OSD menu
erly or not cen-
the selected graphics mode: does the display
-
tered
support the graphics mode of the graphics
board
6. OSD error
-
message "Sig- support the graphics mode of the graphics
nal overrange" board. Be sure to select a graphics mode that
is supported by the display.
© 2009 by Canvys
the selected graphics mode: does the display
Users manual PD-CP52SS
Page 45