Set-Up For Operation; Mounting Instructions - Canvys PD-CP52SS Bedienungsanleitung

Users manual PD-CP52SS

Set-up for Operation

Mounting Instructions

Do not set up the flat-panel display in direct sunlight.
For operation, the flat-panel display must be installed in an enclosure
so that the operator can only touch the bezel, protective glass overlay,
or the LCD module.
The following cautions must be observed without fail during mounting
of the display. Otherwise, the flat-panel display may be damaged or
even destroyed. The warranty does not cover damage resulting from
failure to observe the following instructions:
Caution — Equipment Damage
When mounting the flat-panel display, be sure to allow ade-
-
quate air circulation for cooling of the display. The ventilation
holes of the flat-panel display must not be obstructed. The
ambient conditions stated in the "Technical Specifications"
chapter must be ensured at all times.
The flat-panel display must not be twisted during mounting.
-
The same applies to the mounting straps or angle brackets.
Use an appropriate mounting device to ensure that no pres-
-
sure is exerted on the LCD module while it is installed (or op-
erated).
The so-called chassis models must be mounted such that no
-
pressure is exerted on the LCD module once installed. For this
reason, on models with foam rubber strips these strips must
not be compressed more than 0.2 mm.
Page 34 © 2009 by Canvys