Beko WMY 111444 LB1 Bedienungsanleitung Seite 55

Problem
Laundry became stiff after
washing. (**)
Laundry does not smell like the
softener. (**)
Detergent residue in the detergent
drawer. (**)
Too much foam forms in the
machine. (**)
Foam is overflowing from the
detergent drawer.
Laundry remains wet at the end of
the programme. (*)
(*) Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to the machine
and to its surrounding environment. Laundry should be rearranged and re-spun.
(**) Regular drum cleaning is not applied. Clean the drum regularly. See 4.7.2
A
CAUTION:
Authorized Service Agent. Never try to repair a nonfunctional product yourself.
Washing Machine / User's Manual
Reason
Insufficient amount of detergent is used.
Detergent is put in the wrong compartment.
Detergent might be mixed with the softener.
Detergent is put in the wrong compartment.
Detergent might be mixed with the softener.
Detergent is put in wet drawer.
Detergent has gotten damp.
Water pressure is low.
The detergent in the main wash compartment got
wet while taking in the prewash water. Holes of the
detergent compartment are blocked.
There is a problem with the detergent drawer valves.
Detergent might be mixed with the softener.
Regular drum cleaning is not applied.
Improper detergents for the washing machine are
being used.
Excessive amount of detergent is used.
Detergent was stored under improper conditions.
Some meshed laundry such as tulle may foam too
much because of their texture.
Detergent is put in the wrong compartment.
Softener is being taken early.
Too much detergent is used.
Excessive foam might have occurred and automatic
foam absorption system might have been activated
due to too much detergent usage.
If you cannot eliminate the problem although you follow the instructions in this section, consult your dealer or the
Solution
Š Using insufficient amount of detergent for the
water hardness can cause the laundry to become
stiff in time. Use appropriate amount of detergent
according to the water hardness.
Š If detergent is put in the prewash compartment
although prewash cycle is not selected, machine
can take this detergent during rinsing or
softener step. Put the detergent in the correct
compartment.
Š Do not mix the softener with detergent. Wash and
clean the dispenser with hot water.
Š If detergent is put in the prewash compartment
although prewash cycle is not selected,
machine can take this detergent during rinsing
or softener step. Wash and clean the dispenser
with hot water. Put the detergent in the correct
compartment.
Š Do not mix the softener with detergent. Wash and
clean the dispenser with hot water.
Š Dry the detergent drawer before putting in
detergent.
Š Keep detergents closed in an environment free
of humidity and do not expose them to excessive
temperatures.
Š Check the water pressure.
Š Check the holes and clean if they are clogged.
Š Call the Authorized Service Agent.
Š Do not mix the softener with detergent. Wash and
clean the dispenser with hot water.
Š Clean the drum regularly. For this, please see
4.7.2.
Š Use detergents appropriate for the washing
machine.
Š Use only sufficient amount of detergent.
Š Store detergent in a closed and dry location. Do
not store in excessively hot places.
Š Use smaller amounts of detergent for this type
of item.
Š Put the detergent in the correct compartment.
Š There may be problem in the valves or in the
detergent dispenser. Call the Authorized Service
Agent.
Š Mix 1 tablespoonful softener and ½ l water and
pour into the main wash compartment of the
detergent drawer.
Š Put detergent into the machine suitable for the
programmes and maximum loads indicated in the
"Programme and consumption table". When you
use additional chemicals (stain removers, bleachs
and etc), reduce the amount of detergent.
Š Use recommended amount of detergent.
55 / EN