General Safety Instructions - Renkforce 23 L Bedienungsanleitung

• Do not use abrasive cleaners or metal scrapers to clean the
microwave door. This may scratch the door surface and cause
the glass to crack.
• Do not use a steam or pressure cleaner to the clean the device.
• Never operate the product without the glass tray.

7. General safety instructions

Read the operating instructions carefully and especially observe the safety information. If you
do not follow the safety instructions and information on proper handling in this manual, we
assume no liability for any resulting personal injury or damage to property. Such cases will
invalidate the warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become dangerous
playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it
from any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage
the product.
• Only install and use the product indoors in dry and closed rooms. It may not become moist or
wet.
• A properly installed, isolated main socket (230 V/AC, 50 Hz) only may be used as a power
source.
• Before plugging in the device, verify that the information on the product's rating plate
correspond with your household power supply.
• The mains outlet must be located near to the device and be easily accessible.
• Always lay the cables so that nobody can trip over or become entangled in them. This poses
a risk of injury.
• When setting up the product, make sure that the cable is not pinched, kinked or damaged by
sharp edges.
29