Technical Characteristics; Safety Instructions; Putting Into Operation - Makita UT120 Betriebsanleitung

ENGLISH tzr

Technical Characteristics

Rated voltage:
Rated power input:
Frequency:
Load speed:
Maximum basket diameter:
Protection class:
Degree of protection:
Collet:
Weight:
All rights of changes due to technical development reserved.

Safety Instructions

Read and obey these instructions before using this machine.
ADDITIONAL SAFETY RULES FOR THIS MACHINE
1. Disconnect from mains supply whenever any work, servicing and adjustment or change of
accessories and cutters is required.
2. Only grip by insulated part of auxiliary handle and other plastic surfaces when performing drilling
where cutter is likely to contact hidden electrical wiring or its own cable. Contact with a "Live"
wiring will make all exposed metal surfaces of the machine "Live" and danger for an electric shock.
3. Before using the machine, inspect and check power cord and plug for signs of damage and if any
found, have these repaired or replaced immediately. Plug the cord in only after making sure that
mains switch is OFF.
4. Machine should never be damp or wet. Do not use the machine in damp or wet locations.
5. When working this tool always use auxiliary side handle and hold the machine firmly with both
hands. Keep secure stance.
6. For longer machine use, wear hearing protectors.
7. Likewise it is recommended to wear safety helmet, safety glasses and/or face shield. Also wear a
dust mask and thickly padded gloves.
8. Prior to work starting, make sure that cutting accessory is fitted properly.
9. Keep hands well away from rotating parts.
10. Do not leave the machine running unattended. Switch ON only when hand-held.
11. To avoid machine self-starting, always trigger-off the switch should power supply become
interrupted or plug accidentally withdrawn from the socket while motor is still running.
12. When machine is used outdoors, only use extension cords intended and approved for such
application by complying with your local regulations.
13. Always have mains cable routed to the rear and away from the machine and moving parts.
14. Keep sure-footing and body balance at all times for better control of reaction torque.
Protection
Wrong handling can result in damages. Hence, the following instruction should be observed:
Use only Makita paddles with M14 internal thread. Do not allow blocking of the tool due to overload.
Use only original parts from Makita.

Putting into Operation

The operating voltage must correspond with that indicated on identification plate. Mashines designed for 110 V
can be used with 120 V as well.
110 V
1150 W
50 - 60 Hz
-1
250 - 580 min
140 mm
II
IP 20
M 14
4,3 kg