Set Up - clearaudio electronic Concept Bedienungsanleitung

Concept
User manual / Bedienungsanleitung

3. Set up

Concept -
The set up of the turntable is easy as the turntable chassis, tonearm and the
cartridge are pre-assembled and all parameters have been already adjusted and tested at the
clearaudio factory.
Concept
The - turntable requires a place for set-up of at least 17 inch x 14 inch.
1.)
Concept
Please take first the - turntable chassis out of the package and place it on a suitable
surface. After that please take the accessory box out of the package.
2.)
Please remove the adhesive security tape from the sub-platter.
Pic. 2: Removing the security tape
3.)
Take the drive belt out of the accessory box and place it around the sub-platter and around
the motor pulley.
4.)
Take the platter out of the package and place it carefully with both hands onto the shaft.
Pic. 3: Set up of the platter
5.)
Now remove carefully the adhesive security tape
from the tonearm and the cartridge.
Pic. 4: Removing the tapes
Page/ Seite 4  clearaudio electronic GmbH 2009