Connect Antenna Cable; Power Connection; Initial Installation; Select Source - AEG CTV 2404 LED-DVB-T Bedienungsanleitung

ENGLISH
56

4.3 Connect Antenna Cable

The TV set festures a tuner to receive TV signals via antenna/cable and DVB-T signals.
CAUTION:
• Connect the antenna cable before connecting to mains power supply.
• DVB-T reception: The device is intended for reception via passive DVB-T antenna.
• Connect the DVB-T antenna to ANT input.
• In the source menu (press SOURCE button) select DTV.
Other Antenna Connections
For optimum trouble-free picture quality use a dual shielded 75 ohm antenna cable.
1. Connect a 75 ohm antenna cable to the antenna wall outlet.
2. Connect the other end to antenna input ANT at the rear of the device.
3. In the source menu (press SOURCE button) select ATV.
NOTE:
To be able to watch TV you first have to search for channels ( see "4.5 Initial Installation" on page 56).

4.4 Power Connection

The power supply is designed for AC 100-240 V~ 50/60 Hz.
• Connect the power supply to the DC 12 V/3 A jack on the TV set. Then plug the power supply into a properly installed
wall socket.
CAUTION:
Connect all devices before connecting the TV set to mains power supply. The wall outlet must be freely accessible at all
times.

4.5 Initial Installation

When turning the TV set on for the first time a window is displayed to
select the menu language and to start Channel Search.
1. When the indicator light turns red, press the POWER
the remote control. The "Select OSD Language" window is dis-
played.
2. Press OK to confirm German as OSD language or press the arrow
buttons / / / on the remote control and OK to select your
language.
3. Press the arrow buttons / / / to select the country of your location.
4. Press OK to start Channel search. This process will take a few minutes. Progress is displayed on screen.

4.6 Select Source

button on
1. In on mode press the SOURCE button. The source menu (connected devices) is dis-
played.
2. Press the arrow buttons / on the remote control or CH +/- on the device to select
the desired source.
3. Press OK or VOL +/- on the device to confirm.
NOTE:
Press the EXIT button to exit the menu without changes.