AEG FAVORIT 55002 VI0P Benutzerinformation Seite 24

24 www.aeg.com
until the indicators of buttons
3.
Press button
• The indicators of buttons
and
•
The indicator of button
tinues to flash.
• The acoustic signals operate, e.g.
five intermittent acoustic signals =
level 5.
6.2 Filling the salt container
6.3 Filling the rinse aid dispenser
and start to flash.
.
go off.
A
A
+ -
• The display shows the current set-
,
ting of the water softener, e.g.
= level 5.
4.
Press button
change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
con-
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt con-
tainer (only for the first time).
3. Fill the salt container with dishwash-
er salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
1. Press the release button (D) to open
B
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
C
You can turn the selector of the
released quantity (B) between
D
position 1 (lowest quantity) and
position 4 (highest quantity).
again and again to