Cleaning The Hob; Troubleshooting; Installation - Leonard LES6061F Benutzerinformation

Cleaning the hob

• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar. If
not, the dirt can cause damage to the
hob. Take care to avoid burns. Put the
special scraper on the glass surface at
an acute angle and move the blade on
the surface.
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
You cannot activate or oper-
ate the hob.
Residual heat indicator does
not come on.
There is a dark area on
the multiple zone.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Make sure, you
operated the hob correctly. If not the

INSTALLATION

WARNING! Refer to Safety
chapters.
stains, shiny metallic discoloration. Clean
the hob with a moist cloth and non-
abrasive detergent. After cleaning, wipe
the hob dry with a soft cloth.
• Remove shiny metallic discoloration:
use a solution of water with vinegar and
clean the glass surface with a moist
cloth.
Possible cause
The fuse is blown.
The zone is not hot because
it operated only for a short
time.
It is normal that there is a
dark area on the multiple
zone.
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.
Hob and oven connection type
This appliance has an orange 1x14 pole
connector and can be connected to an
oven with an orange 1x14 pole connector.
Leonard 17
Remedy
Make sure that the fuse is the
cause of the malfunction. If
the fuse is blown again and
again, contact a qualified
electrician.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.