Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Remote Control Handset
Inserting Batteries
•
Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
•
Insert two
AAA/R3 or equivalent type batteries
inside. Insert two AAA/R3 or equivalent type
batteries inside. Observe the correct polarity (+/-)
when inserting batteries and replace the battery
cover.
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
•
Connect the power cord to the 220-240V AC, 50
Hz socket.
•
Then the standby LED lights up.
•
To switch on the TV from standby mode either:
•
Press the "
" button, P+ / P- or a numeric button
on the remote control.
•
Press the control switch left side of the TV. The TV
will then switch on.
Note:
If you switch on your TV via standby button on the
remote control, the programme/source that you were watching
last will be reselected. The TV will switch on with the last
selected channel number, regardless of the channel number
that you select from the remote control to switch on the TV.
By either method the TV will switch on.
To Switch the TV Off
•
Press the "
" button on the remote control or hold
the control switch on the Tv until shut down , so the
TV will switch to standby mode.
•
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active. The LED can also blink when you switch on
the TV from standby mode.
Standby Notifications
If the TV switches off while in No Signal mode, the
following on-screen message will be displayed on the
next switch-on:
When the Auto Tv Off timeout is reached, the following
message will be displayed on the screen. Select YES
to shut down the TV. Select NO to cancel. The TV
will switch off as well, if you do not make a selection
on this screen.
If the TV switches off owing to the auto power down
feature, the following on-screen message will be
displayed on the next switch-on:
Digital Teletext (** for UK only)
• Press the "
•
The digital teletext information appears.
•
Operate it with the coloured buttons, cursor buttons
and OK button.
The operation method may differ depending on the
contents of the digital teletext.
Follow the instructions displayed on digital teletext
screen.
•
When Press "
on the screen, press the OK button.
•
When the "
television broadcasting.
•
With digital broadcasting (DVB), in addition to digital
teletext broadcasting together with the normal
broadcasting, there are also channels with just digital
teletext broadcasting.
English - 63 -
" button.
OK" button or similar message appears
" button is pressed, the TV returns to
Werbung
Kapitel
Inhaltsverzeichnis
