Product Introduction; Front View; Rear View; Connections - Seg LED 2410 Bedienungsanleitung

Product Introduction

Front View

MENU CH- CH+ VOL-
LED indicator
(IR) Infrared Receiver: Receives IR signals from the remote control.
(Power on/Standby) LED indicator: Press POWER to turn on and off.
Indicator on(Red)
Indicator on(Green)
The effective receiving range for the signal is 5-8 metres from the front of the remote
control window, and 30
window.

Rear View

Wall Mounting
The TV is provided with mounting holes for a VESA approved wallmounting bracket (NOT SUPPLIED).
Remove the Posi screws holding the base to the base bracket and lift the base away (do not remove the
basemounting bracket).Mount the VESA bracket using 4xM4x10mm ISO metric threaded screws (not
supplied). Do not use screws longer than 10 mm, it will occur damage to the internal parts. Fit the wall
bracket securely following themanufacturers instructions.
VOL+ SOURCE POWER
Remote Control window(keep clear)
to the left or right side and 20
0
Headphone out
POWER USB HDMI VGA PC-IN SCART
61 cm (24") LED BLU-TV
MENU: Display/exit the OSD menu.
CH+/-: Scan through channels.
VOL+/-: Adjust the volume.
SOURCE: Display the input source menu.
POWER: Turn on/standby the TV set.
Standby mode
Power on mode
above or below the control
0

Connections

See next page
5