Specifications - Rockford Fosgate Punch PBR300X4 Einbau Und Betrieb

S
PECIFICATIONS
MODEL- PUNCH
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Stereo
Dimensions: Height
Width
Length
External Battery Fuse Rating
"A" Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms
"A" Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms
Crossover Slope
Crossover Frequency
Frequency Response
Signal Voltage Adjustment Range
Protection
Input Impedance
Operating Voltage
CMRR (Common Mode Rejection Ratio)
Damping Factor
THD+N (Total Harmonic Distortion+Noise)
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice
10
PBR300X4
75 Watts x 4
1.53" (3.90cm)
4.25" (10.8cm)
6.75" (17.2cm)
30A
≥80 dB
≥100 dB
12dB/octave Butterworth
80Hz LP/AP/HP
20Hz to 20kHz ±1.0dB
Variable from 150mV to 11V
Short circuit protection shut downs the amplifier in
case of very low impedance, shorted speaker wires, or
shuts down the am pli fi er in case of overheating.
20K ohms
9 to 16 Volts DC
>55dB @ 1kHz
< 0.5% @ 4 ohm
>200