Adjustable Parameters; Parameter Adjustment Procedure; Parking Brake Inhibit; Monitor Mechanism - ZENEC ZE-MC172 Betriebsanleitung

ADJUSTABLE PARAMETERS

■ While in DVD, iPOD or TUNER mode, the only parameter that can be adjusted is
brightness (BRIGHT).
■ To access "PICTURE", "COLOR", "CONTRAST", and "TINT" you must be in AUX or
CAMERA mode.

PARAMETER ADJUSTMENT PROCEDURE

1. Enter picture quality setting mode:
Press the PIC button on the remote control or press and hold the INFO button on the
front panel.
2. Select item to be set:
Press the
[] or []
clockwise/anticlockwise to select an item.
3. Set parameters:
Press the
[] or []
on the front panel to adjust the selected feature to the desired setting.
4. Exit picture quality setting mode:
Press the PIC button on the remote control or press and hold the INFO button on the
unit.

PARKING BRAKE INHIBIT

■ When the "PARKING" cable is connected to the brake switch, the display on the TFT
monitor will display video only, when the vehicle is stopped and the parking brake is
engaged.
■ Parking brake function is overridden, when the video source is set to CAMERA.
■ When the parking brake inhibit is active, the front monitor displays "Caution", preventing
the driver from watching content while driving. Rear video screens are not affected.
Please see the "INSTALLATION SECTION" for installation.

MONITOR MECHANISM

■ If an obstruction occurs in the monitor path, the motion will stop automatically to prevent
damage to the mechanism or monitor.
■ Normal operation is resumed by pressing the OPEN button
reconnecting the power.
button on the remote control or rotate the Smart Dial button
button on the remote control or press and hold the ANGLE button
[
64 64
or disconnecting and
]