Herunterladen Inhalt Inhalt Diese Seite drucken

Jamara 15 3058 Gebrauchsanleitung Seite 19

Inhaltsverzeichnis

Werbung

4
1
2
5
3
DE - Blei Zellen laden
Mit diesem Programmpunkt lassen sich
Bleiakkus behandeln. Dabei können Ak-
kus mit einer Spannung von 2 bis 20 V (1
– 10 Zellen) sich sowohl laden, als auch
entladen. Bleiakkus werden am besten
mit einem Strom geladen, der 1/10 der
Kapazität des Akkus entspricht, sie soll-
ten nicht schnell geladen werden.
Nach der Aktivierung dieser Funktion
muss die Stromstärke und die Zellenzahl
vorgegeben werden. Der Ladevorgang
wird auf die bekannte Art mit der 'Start/
Enter'-Taste (3 Sek. lang) gestartet.
Im zugehörigen Arbeitsdisplay werden
alle üblichen Parameter des Vorganges
angezeigt. Mit der 'Batt-Type/Stop'-Tas-
te kann die Aufladung jederzeit unter-
brochen werden. Bedenken Sie, dass
der Akku dann nicht voll aufladen ist.
Das Vorgangsende wird im Display und
durch ein akustisches Signal gemeldet.
1 Zellentyp
2 Ladezeit
3 Ladestrom,
4 aktuelle Akkuspannung
5 geladene Kapazität.
GB - Charging of the Pb battery
This program is only suitable for char-
ging Pb(lead-acid)battery with nominal
voltage from 2to 20V.Pb(lead-acid)batte-
ry is completely different from NiCd/NiMh
battery.These batteries can only deliver
current lower in comparison to their ca-
pacity.The same restriction applies to
the charging process.Consequently,the
optimum charge current can only be
1/10 of the capacity. Pb battery can not
be used for fast-charging,please follow
the instructions provided by the battery
manufacturer.
You can press START/ENTER key to
make it blink and alter the value of pa-
rameters using INC or DEC key,press
START/ENTER key to store the value.
Set up the charge current on the left and
nominal voltage on the right Range of
current is 0.1-5.0A,the voltage should
match the battery being charged.Press
START/ENTER key for more than 3 se-
conds to start charging.
The screen displays the real-time di-
scharging status.Press START/ ENTER
key to alter discharge current.Press
START/ENTER key again to store the
parameter value you set.Press BATT
TYPE/STOP key to end the program.
1 Battery type
2 Elapsed time
3 Charge current
4 Battery voltage
5 Charge capacity
Pb
19

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

X-peak 80 bal pult editionX-peak 80 bal pult

Inhaltsverzeichnis