Important Installation Information - MAC Audio Z 2100 Bedienungsanleitung

2. FEATURES
•
Complementary push-pull final stage
•
Automatic switching on/off via car radio
•
Infinitely adjustable high-pass filter 40 – 500 Hz
•
Infinitely adjustable low-pass filter 50 – 250 Hz
•
Infinitely variable bass equalisation
•
Adjustable input sensitivity
•
Bridgeable 2-/1-channel mode
•
Tri-mode
•
Electronic protective circuit against short circuiting, DC offset and excess
temperature
•
Mute switch for suppressing switch-on crackle interference
•
Capsulated loudspeaker and power-supply screw terminals
•
Low-level outputs (cinch jacks) for connecting additional amplifiers
•
Status indicator (green LED) and overload indicator (red LED)
•
Z 2200: Volume remote control (subwoofer operation)
3.

IMPORTANT INSTALLATION INFORMATION

•
This appliance may only be connected to a 12 volt system with negative ground.
•
The heat radiated when the amplifier is used means that sufficient air circulation
is required at the place of installation. It is very important that the cooler's cooler
ribs do not contact any metal plating or any surfaces which could impair air
circulation. The amplifier may not be installed in small confined spaces or spaces
without air circulation (e.g. spare wheel recess or under the vehicle carpeting).
Installation in the boot is recommended.
•
Install the amplifier in such a way that it is protected as far as possible against
vibrations and dust and dirt.
•
Make sure that the input/output cables are sufficiently distant from the power
supply cables as otherwise interference may occur.
•
Make sure that the fuse and operating elements are accessible after installation.
•
The appliance's reliability and performance depend on the quality of installation.
Preferably get an expert to install the system, particularly if you want to install
several loudspeakers or a complex multi-way system.
GB
13