Maintenance And Cleaning - AEG BSS 4810 Bedienungsanleitung

Maintenance and Cleaning

CAUTION:
Never immerse the unit in water!
• There are no parts inside the device which can be maintained by the user.
• Clean the speaker with a slightly damp cloth without cleaning agent.
Troubleshooting
Symptoms
Cannot switch the
speaker on
No audio signal during
Bluetooth connection
Cannot connect
speaker
Possible cause
Battery empty
Audio cable is connected
Speaker is switched off
Speaker is not paired to the
audio source.
Audio cable is connected.
Volume too low
Pairing does not work
Audio source is turned off
Bluetooth is turned off on
the audio source.
Bluetooth version is not sup-
ported.
English
Solution
Charge the battery ( Page 54)
Disconnect the cable.
Switch the speaker on.
Check whether the connection
exists. If necessary, pair the speaker
to the audio source again.
The Bluetooth connection is auto-
matically separated when a cable
is connected to the 3.5 mm plug.
Remove the cable.
Increase the volume on the
speaker
Increase the volume on the audio
source.
Check, whether the audio source
supports the A2DP protocol.
Turn the audio source on
Turn the Bluetooth function on in
the audio source.
Use another playback unit.
59