Changing The Home Automation House Code; Programming The Home Automation Ir/Rf Mode - Marmitek EASYTOUCH35 Betriebsanleitung

To switch on/ off an appliance plugged into an home control module: Press the
key (2), then press the unit code of the home control module on the Touchscreen
display and then press CHAN+ / - (8).
To dim/bright a light plugged into a home control module: press its unit code on the
Touchscreen display and then press VOL+ / - (4).
To turn ON all the home control Lamp modules: Press the Power key (3).
To turn Off all the home control modules (Lamp and appliance): press the
Mute key (7).
12.1. Changing the home control House Code
The preset house code is A. In the majority of cases it is not necessary to change this
setting except if there is interference from neighbouring Marmitek X10 systems. In that
case:
1. Press the Marmitek X-10 Home Control
2. Press and hold SETUP until the LED lights continuously.
3. Release the SETUP button.
4. Press the SETUP button again.
5. Use the digit keys on the Touchscreen display to enter the number equivalent to the
chosen home code (1=A, 2=B, ... 16=P).
6. Press ENTER followed by EXIT to confirm your command.
Note: The code you have chosen has to be the same as the one selected on the
Transceiver module TM13 or the security console, with which you use your remote.
12.2. Programming the Home Control IR/RF mode
Your ET35 remote control can control your electrical appliances using infrared signals (via
an infrared mini-controller IR7243) or RF signals (via a transceiver module TM13). The
key is set to RF mode by factory setting.
To program the
1. Activate your ET35 remote by touching the screen
2. Press and hold the Setup key until the LED remains on (this occurs after approximately
2-3 seconds) and display shows the Main Setup Screen.
3. Release Setup key.
4. Press and release the Touchscreen "CODE" Key.
5. Display will show the Mode Setup Screen. Press and release Marmitek X-10 Home
Control key
18
key to send an Infrared signal, proceed as follow
.
key
MARMITEK