Beamz S700-LS Bedienungsanleitung Seite 12

 Do not use laser if the laser appears to be emitting only
one or two beams
 Do not use laser if housing is damaged or open, or if
optics appear damaged in any way.
 Never open the laser housing. The high laser power
levels inside of the protective housing can start fires,
burn skin and will cause instant eye injury.
 Never leave this device running unattended.
 The operation of a class 3B laser show laser is only
allowed if the show is controlled by a skilled and well-
trained operator familiar with the data included in this
manual.
 The legal requirements for using laser entertainment
products vary from country to country. The user is
responsible for the legal requirements at the
location/country of use.
 Always use appropriate lighting safety cables when
hanging lights and effects overhead.
 Please consider that damages caused by manual
modifications to the devise are not subject to warranty.
 Never let the power-cord come into contact with other
cables! Handle the power-cord and all connections with
the mains with particular caution!
 Make sure that the available voltage is not higher than
stated on the rear panel.
 Always plug in the power plug least. Make sure that the
power-switch is set to off-position before you connect the
device to the mains. The power-plug has to be accessed
after installing the device.
This device has left out premises in absolutely perfect condition. In order to maintain this condition and to ensure a safe
operation, it is necessary for the user to follow the safety instructions and warning notes written in this manual.
Important!
The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any
unauthorized modification to the device.
Proper Laser Set Up & Usage
This fixture has been designed to be hung. It is recommended for safety purposes, your lighting effect are properly
mounted using a suitable hanging clamp and safety cable. Items appropriate for safe and effective mounting are easily
sourced from your lighting vendor. International laser safety regulations require that lasers must be operated in the
fashion illustrated below, with a minimum of 3 meters (9.8 ft) of vertical separation between the floor and the lowest laser
light vertically. Additionally, 2.5 meters of horizontal separation is required between laser light and audience or other
public spaces.
 Make sure that the power-cord is never crimped or
damaged by sharp edges. Check the device and the
power-cord from time to time.
 Always disconnect from the mains, when the devise is
not in use or before cleaning it. Only handle the power-
cord by the plug. Never pull out the plug by tugging the
power-cord.
 The electric connection, repairs and servicing must be
carried out by a qualified employee.
 Do not switch the fixture on and off in short intervals as
this would reduce the laser diode life.
 If the device has been exposed to drastic temperature
fluctuation, do not switch it on immediately. The arising
condensation water might damage your device. Leave
the device switched off until it has reached room
temperature.
 Do not shake the device. Avoid brute force when
installing or operating the device.
 When choosing the installation-spot, please make sure
that the device is not exposed to extreme heat, moisture
or dust. There should not be any cables lying around.
You endanger your own and the safety of others!
 The minimum distance between the fixture and
surrounding walls must be more than 50cm.
 Always fix the fixture with an appropriate safety-rope. Fix
the safety-rope at the safety-rope only.
 The ambient temperature must be between 10 to 40
degrees.
 Please use the original packaging if the device is to be
transported.
 Please consider that unauthorized modifications on the
device are forbidden due to safety reasons!
- 12 -