Beamz S700-LS Bedienungsanleitung Seite 11

LASER SAFETY LABEL REPRODUCTIONS
(GB) LASER EFFECT
This manual contains important laser system safety and operation information. Read and understand all instructions
prior to powering on laser unit the first time, to avoid laser eye injury and to avoid breaking the law. Keep this manual in
a safe place for future reference.
WARNING DATA
Lasers can be hazardous and have unique safety considerations. Permanent eye injury and blindness is possible if
lasers are used incorrectly. Pay close attention to each safety REMARK and WARNING statement in the user manual.
Read all instructions carefully BEFORE operating this device.
NON-INTERLOCKED HOUSING WARNING
This unit contains high power laser devices internally. Do not open the laser housing, due to potential exposure to
unsafe levels of laser radiation. The laser power levels accessible if the unit is opened can cause instant blindness, skin
burns and fires.
LASER SAFETY AND OPERATING INSTRUCTIONS
STOP AND READ ALL LASER SAFETY DATA. Laser Light is different from any other light source with which you may
be familiar. The light from this product can potentially cause eye injury if not set up and used properly. Laser light is
thousands of times more concentrated than light from any other kind of light source. This concentration of light power
can cause instant eye injuries, primarily by burning the retina (the light sensitive portion at the back of the eye). Even if
you cannot feel "heat" from a laser beam, it can still potentially injure or blind you or your audience. Even very small
amounts of laser light are potentially hazardous even at long distances. Laser eye injuries can happen quicker than you
can blink. It is incorrect to think that because these laser entertainment products split the laser into hundreds of beams
or laser beam is scanned out in high speed, that an individual laser beam is safe for eye exposure. This laser product
uses dozens of mini Watts of laser power (Class 3B levels internally). Many of the individual beams are potentially
hazardous to the eyes. It is also incorrect to assume that because the laser light is moving, it is safe. This is not true.
Nor, do the laser beams always move. Since eye injuries can occur instantly, it is critical to prevent the possibility of any
direct eye exposure. In the laser safety regulation, it is not legal to aim Class 3B lasers in areas which people can get
exposed. This is true even if it is aimed below people's faces, such as on a dance floor.
 LASER LIGHT AVOID DIRECT EYE EXPOSURE
 Avoid direct eye contact with laser light. Never
intentionally expose your eyes or others to direct laser
light..
 This laser product can potentially cause instant eye injury
or blindness if laser light directly strikes the eyes.
 It is illegal and dangerous to shine this laser into
audience areas, where the audience or other personnel
could get direct laser beams or bright reflections into their
eyes.
 It is an offense to shine any laser at aircraft.
 There are no user serviceable parts inside the unit. Do
not open the housing or attempt any repairs yourself. In
the unlikely event your unit may require service, please
contact your dealer..
 Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
 Do not operate laser without first reading and
understanding all safety and technical data in this manual
Caution – Class 3B LASER RADIATION, WHEN OPEN, AVOID EXPOSURE TO BEAM
LASER RADIOATION AVOID EXPOSURE TO BEAM CLASS 3B LASER PRODUCT.
The label indicates the laser beam output aperture
.
 Always set up and install all laser effects so that all laser
light is at least 3 meters (9.8 feet) above the floor on
which people can stand. See section later in this manual
 After set up, and prior to public use test laser to ensure
proper function. Do not use if any defect is detected. Do
not use if laser emits only one or two laser beams rather
than dozens/hundreds, as this could indicate damage to
the diffraction grating optic, and could allow emission of
higher laser levels.
 Do not point lasers at people or animals.
 Never look into the laser aperture or laser beams
 Do not point lasers in areas in which people can
potentially get exposed, such as uncontrolled balconies,
etc.
 Do not point lasers at highly reflective surfaces such as
windows, mirrors and shiny metal. Even laser reflections
can be hazardous.
 Never point a laser at aircraft, this is a federal offense
 Never point un-terminated laser beams into the sky
 Do not expose the output optic (aperture) to cleaning
chemicals
- 11 -