Boiler Installation - Baxi ht 1.350 Gebrauchsanleitung

Remember that the presence of foreign matter in the heating system can adversely affect the operation of the boiler (e.g.
overheating and noisy operation of the heat ex­changer).
Failure to observe the above will render the guarantee null and void.
Decide upon the boiler location, then tape the template on the wall.
Connect the pipework to the gas and water inlets prearranged on the template lower bar.
If you are either installing the boiler on a pre-ex­istent system or substituting it, we suggest you also fit settling tanks on
the system return pipework and under the boiler to collect the deposits and scaling which may remain and be circulated
in the system after the purge.
When the boiler is fix­ed on the template connect the flue and air ducts (fittings supplied by the manufacturer) according
to the instructions given in the following sections.
Connect the condensate outlet to the siphon supplied with the boiler. Connect the siphon to a drain, making sure there is
a continuous slope. Horizontal sections must be avoided.
The boiler unit is fitted for connection to an ex­ternal boiler. For this purpose, unscrew the two plugs on the heating system
delivery/return fittings if a hydraulic separator is not used (see fig. 12).
DRILL HOLES WITH A Ø12 BIT, FIT THE MASONRY
PLUGS AND THE SCREWS PROVIDED
N.B. INCLUDE CONDENSATE DRAIN POINT
Figure 5
924.493.3

10. boiler installation

BOILER WIDTH 600
Mr: g 1" heating flow
gas: g 3/4" gas inlet to the boiler
rr: g 1" heating return
sc: condensation drain
instructions pertaining to the instaLLer
81
it
at
gB