Seite 2
BEFORE YOU START! To ensure optimal playability of backboard system, a close tolerance fit between the elevator components and hardware is required. Test fit large bolts into large holes of elevator tubes, backboard brackets and triangle plates. Carefully rock them in a circular motion to ream out any excess paint from holes if necessary.
Seite 5
WARNING: TWO PERSON MINIMUM REQUIRED FOR THIS PROCEDURE. NOT FOLLOWING RECOMMENDATION MAY RESULT IN BODILY INJURY. Support pole on sawhorse. Attach upper and lower elevator tubes (44) to upper pole section (4) using bolts (43) and nuts (39) as shown. Attach pole cap (22) as shown.
Seite 6
PARTS LIST - See Hardware Identifier Item Qty. Part No. Description Item Qty. Part No. Description 900846 Backboard Bracket 206657 Tank, (Black) 206305 Clevis Pin 1/4 x 2-9/32 Large 200628 Wheel Axle 203113 Bolt, Hex Flange , 5/16-18 x 2 1/2 Long 226401 Wheel, 4“...
Seite 7
IMPORTANT! WRITE MODEL NUMBER FROM BOX ONTO PAGE 1 OF THIS OWNERS MANUAL TOP POLE 35-1/4” MIDDLE POLE 43” BOTTOM POLE 43” IMPORTANT! (See Text Page) IMPORTANT! Note (See Text Page) (See Text Page) Note (See Text Page) WOOD SCRAP WOOD SCRAP 02/04 P/N 21185802...
Seite 8
IMPORTANT! (See Text Page) Note (See Text Page) P/N 21185802 02/04...
Seite 13
Install net clips. Installez les pinces du filet. Netzhalteklammern anbringen. Instale los sujetadores de la red. WARNING: Use of this product without proper installation of net clips, or when all net clips are not present could result in bodily harm. Be sure to follow directions carefully. CLIP “ARM”...
Seite 14
Install net. SIDE VIEW VUE DE CÔTÉ Installez le filet. SEITENANSICHT VISTA LATERAL NETCLIP Das Netz anbringen PINCE DE FILET NETZHALTEKLAMMER Instale la red. SUJETADOR DE LA RED FILET NETZ Insert net into bottom of clip as shown. Insérez le filet dans la base de la pince, comme illustré. Das Netz wie gezeigt unten in den Clip stecken.
Seite 15
WARNING SEE TEXT PAGE IMPORTANT! (See Text Page) 10 ft. (3.05 m) 02/04 P/N 21185802...