Optional Accessories; Controls - Fohhn FP-11 Bedienungsanleitung

4.2 Optional Accessories

FP-11
• Padded carrying bag for FP-11
• Raincover for FP-11,
• SHP1 stand adapter for FP-11
WHP1 wall bracket for FP-11
•
• WHP1 wall bracket for FP-11
• Loudspeakerstand
•
Microphone stand with boom
•
Carrying bag for two stands

4.3 Controls

(Refer to illustrations on page 31)
Most controls on the FP-11 are located on the back of the speaker.
The squelch control (10) and the channel selector switch (11) for
the radio receiver, which is fitted as an option.
A sturdy carrying handle is integrated in the rear panel of the
enclosure.
(1) recharge battery
Input jack for charging the integrated battery or operating the
EasyPort® on AC power. Please use the AC adapter
(2) Power pack charge status display
Charge mode, charging time 12 hours. If the yellow LED lights
up continuously, the FP-11 is in charge mode, the LED then
flashes when the FP-11 is in trickle charching mode.
(3) power switch
Switches power to the EasyPort® FP-11 audio section and
amplifier on and off but does not affect the charging circuit.
(4) Status display
Status LED, multi-coloured, charge status of the power pack is
indicated by a flashing sequence.
When the FP-11 is switched on, the LED lights up green if the
power pack is fully charged.
If the power pack voltage is decreasing, the LED lights up red
continuously.
After the LED is lit for 10 seconds, the FP-11 switches off to
prevent the power pack from an exhaustive discharge.
20 | FP-11
provits and tilts
,
speaker removable
,
music
(5) line input l/r
These two RCA jacks allow you to conect a CD player, cassette
recorder, or other line level source to your EasyPort® using
a stereo RCA cable (not supplied). The stereo input signal is
internally summed to mono.
Input sensitivity is 100 mV into 10 kΩ for nominal level.
(6)
volume
This rotary potentiometer sets the loudness volume of the
audio source connected to the line input l/r jacks (5).
(7) line out l/r
These two RCA jacks allow you to connect either a recorder or
another EasyPort® to your unit using a stereo RCA cable (not
supplied).
The two jacks are internally paralleled and carry the output
signal of the built-in mixer with all the volume and EQ settings
you made. The output voltage at nominal level is 0,5 V into
200 Ω source impedance.
wired mic
(8) input
This balanced female XLR connector allows you to connect a
wired microphone (optional) via a standard microphone cable
with a male XLR connector (optional). Since the microphone
INPUT provides 12 V phantom power you can connect both
dynamic and electret or condenser microphones.
Input sensitivy for nominal level is 2 mV into 1 kΩ.
Pin 1 is ground, pin 2 „hot" (inphase), pin 3 return.
(9) volume
This rotary potentiometer sets the loudness volume of the
microphone connected to the INPUT connector (8).
wireless mic
(10) wireless receiver
(11)
(10) squelch, (11) channel
For details on the optional wireless receiver please refer to the
enclosed instruction manual for the receiver.
(12) volume
This rotary potentiometer sets the loudness volume of the
wireless microphone.
EQ
The two-band equalizer acts on the microphone and line inputs.
(13) bass
Rotary control for cutting or boosting the low frequencies.
(14) treble
Rotary control for cutting or boosting the high frequencies.