Installation; Ventilation Requirements; Electrical Connection; Noises - AEG A92300HLW0 Benutzerinformation

10. INSTALLATION

10.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the lid, you must ensure that it is
made unusable to prevent young
children being trapped inside.
The appliance shall have the
plug accessible after installation.
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar),
but for optimum performance install this
appliance at a location where the ambi-
ent temperature corresponds to the cli-
mate class indicated on the rating plate
of the appliance:
Cli-
mate
class
SN
N
ST
T

10.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating

11. NOISES

There are some sounds during normal
running (compressor, refrigerant circula-
tion).
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.

10.3 Ventilation requirements

1. Put the freezer in horizontal position
on a firm surface. The cabinet must
be on all four feet.
2. Make sure that the clearance be-
tween the appliance and rear wall is
5 cm.
3. Make sure that the clearance be-
tween the appliance and the sides is
5 cm.
The airflow behind the appliance must
be sufficient.
ENGLISH
29