Zanussi ZIT64X Benutzerinformation Seite 22

• The appliance becomes too hot (e.g. when, a
saucepan boils dry). Before you use the ap-
pliance again, the cooking zone must be
cool.
• You use incorrect cookware. The symbol
comes on and the cooking zone deactivates
automatically after 2 minutes.
• You do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the appliance deactivates.
See below.
• The relation between heat setting and times
of the Automatic Switch Off function:
•
, - — 6 hours
•
- — 5 hours
•
— 4 hours
•
- — 1.5 hours
The heat setting
Touch to increase the heat setting. Touch
to decrease the heat setting. The display
shows the heat setting. Touch
same time to deactivate the cooking zone.
Power function
The Power function makes more power availa-
ble to the induction cooking zones. The Power
function can be activated for a limited period of
time ( see Technical Information chapter). After
that, the induction cooking zone automatically
sets back to highest heat setting. To activate,
touch , comes on. To deactivate, change
the heat setting.
Power management
The power management divides the power be-
tween two cooking zones in a pair (see the il-
lustration). The power function increases the
power to the maximum level for one cooking
zone in the pair. The power in the second cook-
ing zone automatically decreases. The heat set-
ting display for the reduced zone changes be-
tween two levels.
22
Timer
Count Down Timer
Use the Count Down Timer to set how long the
cooking zone operates for only this one time.
Set the Timer after the selection of the
cooking zone.
You can set the heat setting before or after you
set the timer.
• To set the cooking zone: touch
and again until the indicator of a necessary
cooking zone comes on.
• To activate or change the Timer: touch
and at the
99
cooking zone starts to flash slow, the time
counts down.
• To deactivate the Timer: set the cooking
zone with
Timer. The remaining time counts back to
. The indicator of the cooking zone goes out.
• To see the remaining time: set the cook-
ing zone with
ing zone starts to flash quickly. The display
shows the remaining time.
When the time comes to an end, the sound op-
erates and
tivates.
• To stop the sound: touch
Minute Minder
You can use the Timer as a Minute Minder
while the cooking zones do not operate. Touch
time comes to an end, the sound operates and
00
• To stop the sound: touch
or of the timer to set the time (
minutes). When the indicator of the
and touch
. The indicator of the cook-
00
flashes. The cooking zone deac-
. Touch or to set the time. When the
flashes
again
00
-
to deactivate the
00
www.zanussi.com