Receive Board Interface Diagram - XciteRC Flybarless 3D 195 Bedienungsanleitung

Troubleshooting
Problem
Turn on the helicopter after bind-
ing succasafully,the propeller ro-
tate constantly but the hellcoptar
can not take off.
Helicopter vibrates os shakes in
flight.
Main rotor blades are shaking in
flying.
Helicopter is out of control when
it takes off.
The sound of the main rotor be-
comes smaller.
Helicopter has no reaction or can
not fly smoothly.

Receive board Interface Diagram

14001000 XciteRC Flybarless 3D 195
Possible cause
Low charge in aircraft batteries
or main gear loose.
Damaged rotor blades and lateral
axis blade grips too tight causing
the movement of the main rotor
isn´t smooth.
Lateral axis is bent; lateral axis
screw is not tight. There are
some debris in the servo, caus-
ing shakes, The loose between
the swash plates. Deformed or
damaged tail rotor blades.
The helicopter isn´t maintained
static level when it is binding.
Low battery voltage of helicopter.
Failure to binding.
Pitch Elevator
Solution
Replace and charge the batter-
ies ;press the spindle with gear
tightly.
Change the main rotor blades,
and lateral axis.; loosen the
bllade grips properly.
Replace the lateral axis. Tighten
the lateral axis screw. Change
the bearing. Remove he servo
and clear debris. Compress the
swash plates. Change tail rotor
blades.
Rebind the TX and RX correctly.
Charge the battery or change a
fully charged battery.
Rebind the helicopter and trans-
mitter, make sure you place the
helicopter static level next to the
transmitter.
Aileron
Tail motor
Main Motor
EN
19