Dmx Control; Making The Connections; Adjusting The Dmx Start Address; Dmx Functions - EuroLite 51707007 Bedienungsanleitung

Making the connections

The unit features 3-pin and 5-pin XLR plugs for DMX connection.
• Connect the output of your DMX controller to the DMX IN jack of the machine with a DMX cable.
• Connect the DMX OUT jack of the machine to the DMX input of the next unit in the chain. Always connect one
output to the input of the next unit until all units are connected.
• At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between Signal (–)
and Signal (+) in the DMX output of the last unit.
• If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended to insert
a DMX level amplifier to ensure proper data transmission.
Occupation of the XLR connection:

Adjusting the DMX start address

When the machine is controlled via DMX signal, DMX mode is activated. The display indicates the current DMX
start address. To ensure that the control signals are properly directed to the machine, it must be adjusted to the
DMX start address provided for it on the DMX controller. Press the ENTER button. Then use the buttons ▲ and ▼
to set the address between 001 and 512. You may now start operating the machine via your DMX controller.
Note
• Please make sure that you do not have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX data link. If two, three or more devices are addressed similarly,
they will work similarly.

DMX functions

Channel
1 Confetti output on/off
2 Red
3 Green
4 Blue
5 Amber
6 Color mix
7 Strobe effect
8 Random color change
9 Brightness

DMX CONTROL

Function
16 • EN