Herunterladen Inhalt Inhalt Diese Seite drucken

EuroLite 51707007 Bedienungsanleitung Seite 13

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Warning – risk of burns and fire
• The admissible ambient temperature range (Ta) is -5 to +45°C. Do not operate the device outside of this
temperature range.
• The housing temperature (Tc) can be up to 50°C during use. Avoid contact by persons and materials.
• Do not illuminate surfaces within 10 cm of the device. This value is indicated on the device by the
symbol.
• Do not use the device near highly flammable materials. Always place the device at a location where sufficient air
circulation is ensured. Leave 50 cm of free space around the device. Never cover the air vents of the housing.
• Keep device upright. Never aim the output nozzle directly at people or animals.
• Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power
cord by the plug. Never pull out the plug by tugging the power cord.
• For commercial use the country-specific accident prevention regulations of the government safety organization
for electrical facilities must be complied with at all times.
Warning – risk of injuries
• Do not look directly at the light source. Persons with light-sensitive epilepsy may suffer from epileptic seizures or
fall unconscious.
• Make sure that the product is set up or installed safely and expertly and prevented from falling down. Comply
with the standards and rules that apply in your country, in particular EN 60598-2-17.
• If you lack the qualification, do not attempt the installation yourself, but instead use a professional installer.
Improper installation can result in bodily injury and or damage to property.
• The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions.
• For overhead use, always secure the device with a secondary safety attachment such as a safety bond or safety
net.
• Make sure that the area below the installation place is blocked when rigging, derigging or servicing the device.
• For commercial use the country-specific accident prevention regulations of the government safety organization
for electrical facilities must be complied with at all times.
Caution – material damage
• This device must not be connected to the mains voltage by means of a dimmer.
• Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
• Never switch the device on and off at short intervals. This will considerably reduce the service life of the device.
• If the device has been exposed to drastic temperature fluctuation, do not switch it on immediately. The resulting
condensation may destroy the device. Allow the device to reach room temperature before connecting it. Wait
until the condensation has evaporated.
• Please use the original packaging to protect the device against vibration, dust and moisture during
transportation or storage.
• If a serial number label is affixed to the device, do not remove the label as this would make the guarantee void.
About batteries
• Do not try to short-circuit, recharge, disassemble or heat batteries (danger of explosion!).
• Remove the batteries if the device is not used for a longer period of time.
• Damaged/leaking batteries may cause harm to your skin–use safety gloves.
EU Declaration of Conformity
Steinigke Showtechnic GmbH hereby declares that this product LED Confetti Storm is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU. The complete Declaration of
Conformity can be found at www.steinigke.de.
13 • EN
- - -m

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Led confetti storm

Inhaltsverzeichnis