Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Placing the unit
• Remove all packing materials from the shipping box. Make sure that there are no packing remnants at the output
nozzle.
• Only install the machine on scratch resistant and water resistant surfaces. Do not orientate the escape nozzle
directly in the direction of the audience's eyes. Keep a minimum distance of 5 m around the device.
• To adjust the output angle, release the fixation screw (8), adjust the desired angle and retighten the fixation
screw.
• Connect the receiver part for the wireless remote control to the corresponding input jack and plug the mains
plug into a wall socket (230 V). Thus, the device is switched on. To turn it off disconnect it from the power
supply.
• Fill the device with loose confetti (accessory).
Suspended installation
Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure that the
device is installed securely and cannot fall down. The installation must be carried out by a specialist
who is familiar with the hazards and the relevant regulations.
The device may be placed on the floor or fastened to a truss or similar rigging structure via two clamps on the
underside. The device must never be fixed swinging freely in the room.
• The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
• Block access below the work area and work from a stable platform when installing the device.
• Use rigging hardware that is compatible with the structure and capable of bearing the weight of the device.
Please refer to the "Accessories" section for a list of suitable rigging hardware.
• Secure the device with a safety bond or other secondary attachment. This secondary safety attachment must be
sufficiently dimensioned in accordance with the latest industrial safety regulations and constructed in a way that
no part of the installation can fall down if the main attachment fails. Use the hole in the bracket for fixation of the
safety rope. Fasten the safety rope in such a way that, in the event of a fall, the maximum drop distance of the
device will not exceed 20 cm.
• After installation, the device requires inspections periodically to prevent the possibility of rot, deformation and
looseness.
OPERATING ELEMENTS AND CONNECTIONS
Output nozzle
Display and operating buttons
3-pin DMX512 connectors
5-pin DMX512 connectors
SETUP
WARNING!
14 • EN
Remote control connector
Power cable
RGBA LEDs
Fixation screw
Werbung
Kapitel
Inhaltsverzeichnis
