Master/Slave Operation; Connection With The Mains; Operation; Stand Alone-Mode - EuroLite LED PAR-64 RGB Bedienungsanleitung

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the DMX start address 001 on every slave-device.

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the EUROLITE LED PAR-64 RGB 24 x 5W starts running.
The LED display lights up and you can choose the desired settings.
The device has two operating modes. It can be operated in Stand-Alone or in DMX-controlled mode.
- STAND-ALONE MODE
• Setting Solid Colors
• Internal Programs
• Sound Control / Sensitivity
- DMX MODE
STAND-ALONE MODE
In Stand-Alone Mode, the LED PAR-64 RGB 24 x 5W can be used without a controller. Disconnect the LED
PAR-64 RGB 24 x 5W from the controller.
International
L
N
18/22 00057276.DOC, Version 1.0