Accessories - Kenwood TS-780 Bedienungsanleitung

2-l. ACCESSORIES
The following accessory items are included with the
unit.
Instruction manual .........................
Fuse 2A (AC) ...............................
7A (DC) ...............................
Foot (with screws) .........................
Speaker plug .................................
plug
DIN .......................................
AC power cord ..............................
DC power cord ..............................
Microphone ..................................
2-3. CABLING FOR ANTENNA, POWER SUPPLY AND OTHERS
4 3 0 M H z
1 4 4 M H z
Ground
To prevent electric shock, TVI and BCI,
select a g o o d grounding l o c a t i o n : Con-
nect the unit to the ground using a heavy
earth line and an appropriate earthing rod.
The earth line should be as short as possi-
ble
. l copy
.2 pieces
.2 pieces
.2 pieces
.l piece
.l piece
. l piece
. l piece
. l piece
I
Check for correct
Connection of electric key
.
Key
F o r C W O p e r a t i o n , connect
the key through a phone plug.
Use shielded cable.
Power supply connection
The power cord has a 4P plug with a lock-
i n g t a b . W h e n c o n n e c t i n g t h e
squeeze the locking tab to ensure that it
properly fits in place. To disconnect the
Cord, squeeze the locking tab again until
if is released from the locked Position.
2-2. OPERATING LOCATION
As with any solid state equipment, the TS-780 should
be kept from extremes of heat and humidity. Choose an
operating location that is dry and cool, and avoid operating
the unit in direct sunlight.
polarity
P o w e r supply
The unit is designed to operate on AC (220 V) or DC (13.8 V). Swit-
Cord,
ching between AC and DC is accomplished by replacing the power cord
(DC power cord is optional.) When connecting the power
to observe the following Points:
1. Turn off the power switch and set the standby switch
tion.
2. When replacing the power Cord,
(or battery) with care.
Failure to observe the above procedure might result in electric shock or
darnage to the unit.
Extemal speaker
A speaker is included in the unit. If you
wish to use an extemal speaker, connect
it by using the supplied speaker plug.
communication-use (lowlhigh cut typel
speaker rated a t 4 - B o h m s i s recom-
mended. The Option speaker (SP-71)
d e s i g n e d to perfectly match t h e chara-
cteristics of the TS-780. Plugging in an
external s p e a k e r w i l l automatically
disconnect the built-in speaker. D
connect the speaker to the PHONES jack,
as this jack has a level adjusting resistor.
Extemal
SP-71
Connection of speaker plug
When connecting an extemal speaker, be
type and should be as short as possible to
prevent RF from being induced.
Cord, be sure
to REC posi-
disconnect it from the AC supply
1
A
is
not
O
speaker