Edge Cleaning - Samsung SR8850 Benutzerhandbuch

Operating the cleaner
USING THE ROBOTIC VACUUM CLEANER

EDGE CLEANING

When the Obstacle Sensor detects an obstacle during
the cleaning, the Robot vacuum Cleaner reduces its
speed to minimize the bumping impact and the Bumper
Sensor also helps it lower the bumping impact. It
cleans the corners by reaching to them as close as
possible. (This Robotic vacuum Cleaner is a touching
type cleaner.)
The robotic vacuum cleaner will move by itself and
automatically clean the house until cleaning is completed once.
If cleaning begins when the robotic vacuum cleaner is docked
■
with the charger station, the time to return to the charger is
decreased since the robotic vacuum cleaner remembers its
original position while moving.
If the battery level becomes too low while cleaning, the robotic
■
vacuum cleaner will automatically return to the charger station
and resume cleaning after charging its battery. (Number of
cleaning operations resumed: Once)
Main unit button
▶
5time
About the Resume Cleaning function
●
If the robotic vacuum cleaner judges cleaning to be
NOTE
complete, resume cleaning is not performed.
●
If you move the robotic vacuum cleaner while it is
being charged or press a button, robotic vacuum
cleaner judges cleaning to be complete (cleaning is
not resumed).
Do not move the robotic vacuum cleaner while it is
cleaning or press a button while cleaning. Otherwise,
CAUTION
the robotic vacuum cleaner judges cleaning to
be complete and starts cleaning again from the
beginning.
Remote control button Configuration Sequence
1
Set the mode.
2
Cancel the mode.
While cleaning
When cleaning is
complete
Operating the cleaner _33