Technical Information - AEG FAVORIT 65072 W0P Benutzerinformation

10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is
too much. Adjust the rinse aid selector
to a lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
• The quality of the detergent can be
the cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent
tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dis-
penser and use rinse aid together with
the combi detergent tablets.
Refer to 'HINTS AND TIPS' for
other possible causes.
10.2 How to activate the rinse
aid dispenser
The activation of the rinse aid dispenser
can occur only with the Multitab option
activated.

11. TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
1. Press the on/off button to activate
2. Press and hold, at the same time, De-
3. Press Start .
4. Press Start to change the setting.
5. Press the on/off button to deactivate
6. Adjust the released quantity of rinse
7. Fill the rinse aid dispenser.
Width / Height / Depth
(mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
"Setting and starting a programme".
lay and Option until the indicators of
, and
start to flash.
• The indicators of
go off.
• The indicator
flash.
• The display shows the current set-
ting.
Rinse aid dis-
penser off
Rinse aid dis-
penser on
the appliance and to confirm the set-
ting.
aid.
(0.5 / 0.05 ) / (8 / 0.8 )
ENGLISH
33
and
continues to
596 / 850 / 610
220-240 V
50 Hz