Other Modes; Listen To Other Devices; Reset; Replace A Fuse - iCartech AURORA 2 Benutzerhandbuch

Listen to Other Devices

You can connect an external audio/video
device to the unit.
1. Connect the external device with the
supplied AV cable.
2. Touch the upper left corner to display the
main menu.
3. Touch [AV-IN 2] = Front input
[AV-IN 1] = Rear input

Reset

When the unit hangs up, you can reset it.
Press [ RESET ] with a ball-point pen or
similar tool.
Tip
When the unit has been reset, all the settings
will return to default settings.

Replace a Fuse

If there is no power, the fuse may be
damaged and need to be replaced.
1. Take out the unit from dashbpard.
2. Check all electrical connections.
3. Buy a fuse that matches the amperage of
the damaged fuse.
4. Replace the fuse while the units power is
disconnected.
i-MODE (Siri) Mode
Connect your iPhone 4S to the unit.
There are two methods to active Siri function.
A. The main uint in Bluetooth menu
Touch [ ] to select Siri on or off.
B. The main uint in SWC menu
1. Programme Siri funciton to one button of
the steering wheel control.
2. Access to Bluetooth mode, press the

Other Modes

Re
set
EN-25
button programmed Siri on the steering wheel
control, the unit will access to voice mode, and
press the button again to exit.
3. If the main is in other mode except Bluetooth,
press and hold the button programmed Siri on
the steering wheel control, the unit will access to
voice mode, and press and hold the button again
to exit.
TV
Touch [DVBT] in the main menu to switch to TV
mode, and touch the center of the screen to show
control buttons.

GPS

1. Touch the upper left corner to display home
menu.
2. Touch [Navi], the navigation menu will display.
3. Refer to the map manual to operate the
navigation tool.
For the GPS system is independent and
complicated, for more details, please refer
to "Navigation manual" (Not included in this
manual) .
Steering Wheel Control Programming
1. Touch the upper left corner to display home
menu.
2. Touch [ SWC ], the SWC menu will display.
3. Press each individual steering wheel control
button for each corresponding function.
4. Once the final steering wheel control button is
programmed, the functions are saved and the
programming will end.
5. Touch [ Reset ] to reset the programming.